Linux aизически сетевка есть, а в интерфейсах нет [QUOTE]# lspci | grep Eth* 01:01.0 Ethernet controller: VIA Technologies, Inc. VT6105/VT6106S [Rhine-III] (rev 8b) 02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19)[/QUOTE] [QUOTE]# ifconfig -a enp2s0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.5.6 netmask 255.255.255.0 broadcast 192.168.5.255 inet6 fe80::2e77:f0f7:35a4:d3a9 prefixlen 64 scopeid 0x20<link> ether 00:13:d4:93:58:87 txqueuelen 1000 (Ethernet) RX packets 1943326 bytes 143705226 (137.0 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 326175 bytes 76381591 (72.8 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 device interrupt 19 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1000 (Local Loopback) RX packets 174169 bytes 15295193 (14.5 MiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 174169 bytes 15295193 (14.5 MiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0[/QUOTE] Как добавить сетевую в интерфейсы? И более интересно, почему система сама не добавила ее? |
P/S/ Забыл сказать, система CentOS Linux release 7.5.1804 (Core) |
modprobe sky2 ? |
# lsmod | grep marv marvell 13186 0 # lsmod | grep sky2 sky2 62332 0 Но сетевки так и нет |
Судя по всему проблема с dlink [QUOTE]# lspci -s 01:01.0 -vv 01:01.0 Ethernet controller: VIA Technologies, Inc. VT6105/VT6106S [Rhine-III] (rev 8b) Subsystem: D-Link System Inc DFE-520TX Fast Ethernet PCI Adapter Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 64 (750ns min, 2000ns max), Cache Line Size: 16 bytes Interrupt: pin A routed to IRQ 10 Region 0: I/O ports at a000 [size=256] Region 1: Memory at cbedfc00 (32-bit, non-prefetchable) [size=256] Capabilities: [44] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- [/QUOTE] С марвел вроде как все нормально, Kernel driver in use: sky2 Kernel modules: sky2 [QUOTE]# lspci -s 02:00.0 -vv 02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19) Subsystem: ASUSTeK Computer Inc. Marvell 88E8053 Gigabit Ethernet controller PCIe (Asus) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0, Cache Line Size: 16 bytes Interrupt: pin A routed to IRQ 24 Region 0: Memory at cbffc000 (64-bit, non-prefetchable) [size=16K] Region 2: I/O ports at c800 [size=256] Expansion ROM at cbfc0000 [disabled] [size=128K] Capabilities: [48] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME- Capabilities: [50] Vital Product Data Product Name: Marvell Yukon 88E8053 Gigabit Ethernet Controller Read-only fields: [PN] Part number: Yukon 88E8053 [EC] Engineering changes: Rev. 1.9 [MN] Manufacture ID: 4d 61 72 76 65 6c 6c [SN] Serial number: AbCdEfG935887 [CP] Extended capability: 01 10 cc 03 [RV] Reserved: checksum good, 9 byte(s) reserved Read/write fields: [RW] Read-write area: 121 byte(s) free End Capabilities: [5c] MSI: Enable+ Count=1/2 Maskable- 64bit+ Address: 00000000fee0200c Data: 41e1 Capabilities: [e0] Express (v1) Legacy Endpoint, MSI 00 DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s unlimited, L1 unlimited ExtTag- AttnBtn- AttnInd- PwrInd- RBE- FLReset- DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported- RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop- MaxPayload 128 bytes, MaxReadReq 512 bytes DevSta: CorrErr+ UncorrErr+ FatalErr- UnsuppReq+ AuxPwr+ TransPend- LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s, Exit Latency L0s <256ns, L1 unlimited ClockPM- Surprise- LLActRep- BwNot- ASPMOptComp- LnkCtl: ASPM Disabled; RCB 128 bytes Disabled- CommClk+ ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt- Kernel driver in use: sky2 Kernel modules: sky2[/QUOTE] |
Решено доставил [url]http://elrepo.reloumirrors.net/elrepo/el7/x86_64/RPMS/kmod-forcedeth-0.64-1.el7.elrepo.x86_64.rpm[/url] вроде как завелась Dlink. Может кому пригодится... |
Текущее время: 20:21. Часовой пояс GMT +3. |